Handyman · Troubleshooting

Door Scraping the Floor or Sagging? Causes and Fixes in Singapore

By SG QuickFixLast updated 7 min read

Quick answer

A door usually scrapes the floor because loose hinge screws, especially on the top hinge, let it drop at the latch side. In HDB flats, new tiles or vinyl and a swollen bottom edge are the next likely causes. Tighten the hinges before trimming anything. SG QuickFix fixes a door scraping the floor from $60.

SG QuickFix pricesTap to WhatsApp

Door scraping floor adjustmentFrom $60
Tighten / resecure loose hingesFrom $60
Door alignment / sagging adjustmentFrom $60
Replace standard hinge+ partsFrom $70
Wooden door minor repairFrom $80

Current SG QuickFix starting prices. Final price confirmed before work begins.

Not sure? WhatsApp us a photo or 10-second video and we'll tell you if it's a DIY fix.

WhatsApp us
Wooden bedroom door in a Singapore HDB flat dragging on the floor tiles, with a scuff arc on the floor

Why is my door scraping the floor?

A door usually scrapes the floor because loose hinge screws, often on the top hinge, let it drop at the latch side.

HDB's home care guide for gates and doors links a door that is hard to open or close to loosened hinge screws, especially on the top hinge. Its fix is to tighten them. The next likely causes are a floor raised by new tiles or vinyl, and a bottom edge that has swollen after getting wet.

Where the door scrapes tells you which, and whether you need a door repair service or just a screwdriver.

Where the door scrapes and what it usually means
Where it scrapesOther signsLikely cause
Bottom corner on the latch sideGap along the top is wider at the latch side; latch sits low on the strike plateDoor sagging on loose or worn hinges
Whole bottom edge, evenlyStarted right after new tiles, vinyl or a thick matFloor level raised
Whole bottom edge, rough or bulgingToilet or kitchen door; laminate lifting at the bottomSwollen bottom edge
One spot in the swing onlyDoor clears the floor when shutUneven tile or a raised threshold lip
Floor and the top of the frameHinge-side frame moves when you push itLoose or cracked door frame
Bedroom door in an HDB flat with its latch-side bottom corner dragging on floor tiles and a wider gap at the top corner

How do I check if loose hinges are the cause?

Open the door to about 90 degrees, lift the handle end, and watch the hinges: any movement at a hinge means loose screws.

  1. Open the door to about 90 degrees.
  2. Lift the handle end gently and watch each hinge for movement or a gap opening.
  3. Start with the top hinge; it carries the most load.
  4. Tighten every screw on both hinge leaves, door side and frame side, with a hand screwdriver.
  5. Note any screw that keeps turning without tightening; its hole is stripped.
  6. Close the door and check whether the scrape and the uneven top gap have gone.

Use a hand screwdriver; a power driver strips worn holes. If the scrape stops, you're done.

How do I fix stripped screw holes or a sagging door?

Pack the stripped hole with glue-coated wooden toothpicks, or fit a longer screw that bites solid timber, then re-drive the screw.

Tightening a spinning screw harder won't help. Two common fixes:

  • Toothpicks and wood glue: push glue-coated toothpicks or matchsticks tightly into the hole, snap them flush, let the glue set, then drive the screw back in.
  • A longer screw: swap in a longer screw of the same thickness on the frame side, so it reaches sound wood. In HDB flats the door frame sits against concrete, brick or drywall, so this helps only if there's solid timber behind the hinge.

If the hinge itself is bent, its knuckle is worn, or it rocks with every screw tight, replace it with one of the same size. On a fire-rated main door, the new hinge must be an approved fire-door hinge under the SCDF Fire Code, so ask the door supplier rather than fitting a standard one. A thin piece of card behind the frame-side leaf of the bottom hinge can lift the latch corner slightly, for small corrections only.

A frame that is cracked around the top hinge, or moves when pushed, gives screws nothing to hold. That needs a frame repair.

Can humidity make a door swell in Singapore?

Yes, but humidity alone rarely does it: a door that keeps swelling usually has an unsealed or damaged edge that gets wet.

Singapore's mean relative humidity is about 82% and does not vary much from month to month, and there is no distinct wet or dry season, though rainfall is higher from November to January, according to the Meteorological Service Singapore. So a door that keeps swelling is usually taking in water through an unsealed edge, not just reacting to the air.

Toilet and kitchen doors suffer most: mopping water and wet floors soak into a bottom edge that was never sealed or has chipped. Look for lifting laminate, a soft or crumbly edge, or bubbling paint.

A laminated or hollow-core door with a soft, delaminated edge usually won't shrink back; it needs trimming and sealing, or replacing. If the damage runs up the door, the same choice applies as when deciding whether to repair or replace an HDB bedroom door.

Close-up of the swollen bottom edge of a laminated toilet door with lifting laminate beside wet floor tiles

Should I trim the bottom of the door?

Only as a last resort, after the hinges are fixed, and never on a fire-rated main door.

Trimming makes sense when new flooring has raised the floor, or the bottom edge has swollen for good. Take off the minimum: one major door maker, JELD-WEN, allows at most about 6 mm off each edge of a flush door, and the solid rail at the bottom of a hollow-core door is narrow. Seal or paint the cut edge the same day: bare wood soaks up moisture and swells again.

The main door is different. HDB says it acts as a fire safety barrier, and SCDF's Fire Code 2023, Clause 3.9 requires fire doors to be built and installed to SS 332, with approved hinges and a self-closing device. If your main door is fire-rated (look for a label on the door edge or frame), don't trim or plane it: cutting changes a tested assembly. Have the hinges adjusted, and ask the door supplier if it still drags. If it also won't shut on its own, see how to adjust an HDB main door closer.

How much does it cost to fix a door scraping the floor in Singapore?

SG QuickFix adjusts a door scraping the floor from $60; hinge, frame and swollen-edge work are priced as separate items.

Door scraping and sagging repairs
JobWhen you need itSG QuickFix price
Door scraping floor adjustmentDoor drags on the floorFrom $60
Tighten or resecure loose hingesHinge screws loose or holes strippedFrom $60
Door alignment or sagging adjustmentLatch side has dropped; door won't latchFrom $60
Replace standard hingeHinge bent or wornFrom $70, plus parts
Wooden door minor repairSwollen or chipped bottom edge to trim and sealFrom $80
Minor door frame repairFrame cracked or loose at the hingesFrom $80
Door closer adjustmentMain door closes too fast or won't shut on its ownFrom $60

The price rises with new hinges, stripped holes in a damaged frame and heavy solid doors; fire-rated main doors may need parts from the door supplier. For an accurate price, send a short video of the door opening and closing, and a photo of the gap along the top. For other jobs, see the full handyman price list for Singapore.

DIY or call a professional
Safe to DIY if…Call a professional if…
Hinge screws are loose but still grip when tightenedScrew holes are stripped in a cracked or crumbling frame
One stripped hole sits in solid timberThe door still scrapes after every hinge screw is tight
A thin shim behind the bottom hinge fixes a small dropThe bottom edge must come off and be sealed square
A solid door swelled slightly and dries backLaminate is lifting or the bottom edge is soft
NeverThe main door is fire-rated: don't trim it or remove its closer; have the hinges or closer adjusted

What happens when you WhatsApp us?

  1. 1WhatsApp us a photo or short video of the problem.
  2. 2We confirm the price before we come.
  3. 3A technician arrives at the agreed time.
  4. 4The job is done and you pay only the confirmed price.

Door Repair

From $60

  • Hinge & alignment repair
  • Closer & handle fix

Door Repair FAQs

Related services

Serving Bedok, Pasir Ris, Punggol, Sengkang and Tampines and island-wide.

Sources & updates
  • Updated 1 Oct 2026: First published
Share:

Related guides

Still need help with door repair?

WhatsApp us a photo and get a clear price before we come. Open 24 hours, island-wide.

WhatsApp us

This guide is general information for homes in Singapore. It is not professional, legal or safety advice for your specific situation. Electrical, gas and some plumbing work can be dangerous, and Singapore law requires certain jobs to be done by licensed workers. Any work you carry out yourself is at your own risk, and SG QuickFix accepts no responsibility for any loss, damage or injury arising from the use of this information. Prices shown are current starting prices, may change, and the final price is confirmed before any work begins. Rules and figures from HDB, PUB, EMA, SP Group and town councils were correct when last checked; please confirm with the relevant authority before acting.

With your permission, we use analytics cookies to measure visits and the results of our ads. Until you choose, we only take cookie-free measurements. See our Privacy Policy.